Category: Whirlpool

Whirlpool F5 E4 on a supported front-load washer means three consecutive cycles were run without the door being opened. The washer may beep when Start is pressed. Open and close the door, then start the intended cycle again. Why the washer checks for door use The control expects the door to open between loads. If…

Whirlpool F3 E1 on a supported top-load washer means the control cannot detect the water level. The manufacturer notes that the appliance control, associated wiring, or the sensing system may be involved. This is not a prompt to add water manually. Protect against overfill first If water is still entering, rising unusually high, or leaking,…

F0 E4 on the Whirlpool top-load washers covered by the manufacturer means the sensed wash-water temperature is too hot. Whirlpool’s first check is the water-supply installation: the hot and cold hoses may be connected to the wrong inlets. Trace each hose end to end Turn the washer off and close both household water valves. Allow…

The Whirlpool Washer DRN Code usually indicates a drainage problem. When the washer cannot remove water from the tub within the expected time, it stops the cycle and displays the DRN error code. In most cases, the issue is caused by a clogged drain hose, blocked drain filter, drain pump obstruction, or a restriction in…

The Whirlpool Washer F7 E1 Code usually points to a basket speed or motor-related problem. In most cases, the washer detects that the basket is not moving the way it expects, or the machine is not receiving the speed feedback it needs to continue the cycle normally. If you want to compare this with other…

The Whirlpool Washer F5 E2 Code usually points to a door lock problem. In most cases, the washer cannot confirm that the door is closed and locked correctly, so it pauses the cycle or refuses to start until the issue is corrected. If you want to compare this with other Whirlpool faults, start with the…

The Whirlpool Washer LOC Code usually means the control lock feature is turned on. In most cases, this is not a real fault code and does not mean the washer is broken. Instead, it means the controls are locked to prevent accidental button presses during or between cycles. If you want to compare this with…

The Whirlpool Washer SUD Code usually means the washer has detected too many suds inside the tub. In most cases, this happens because too much detergent was used, the wrong detergent type was added, or the washer is struggling to clear foam during the cycle. If you want to compare this with other Whirlpool faults,…

The Whirlpool Washer LF Code usually means the washer is taking too long to fill. In most cases, the machine is not getting enough water within the expected time, so the cycle stops and the LF error appears on the display. If you want to compare this with other Whirlpool faults, start with the full…

The Whirlpool Washer F9 E1 Code usually means the washer is not draining properly. In most cases, the machine still detects water inside the tub after the drain phase should be complete, so the cycle stops and the F9 E1 error appears on the display. If you want to compare this with other Whirlpool faults,…