A small amount of water dripping into the door gasket when you open a GE Profile UltraFast Combo can be normal. GE explains that residual water in the dispenser-hose area may fall into the gasket fold. That path helps block airflow during drying and differs from water leaking onto the floor or a drum that remains full.
Why opening the door can release a drip
Movement of the door and gasket can disturb water retained above the opening. Most of it should collect in the fold away from clothing. GE notes that software updates have reduced how often this occurs, so keeping a connected Combo current is part of the model-specific response.
Small adjustments can reduce it
Wait a few seconds before pulling the load out and avoid bumping the upper gasket. Check that the Combo is level front to back rather than leaning forward. The Wrinkle Care option can also reduce the occurrence on supported software.
Keep the drain path clear
- Inspect visible gasket drain holes for lint without using sharp tools.
- Maintain the drain-pump filter at the interval in the manual.
- Wipe the gasket fold and allow it to dry.
- Watch whether water stays inside the fold or reaches the floor.
A leak is a different condition
Stop and arrange service when water escapes the cabinet, the gasket is torn, the door contact area cannot seal, or a significant pool returns after every cycle. Do not remove the boot clamp or dispenser hoses. Those repairs require proper access and leak testing by a technician.
Model and observation notes
Differentiate a drip from standing water. A few drops that fall only when the door moves fit GE’s residual-hose description; a fold that fills during every wash may have blocked drain holes or a leveling problem. Marking the gasket with tape or inserting absorbent material is not recommended because it can interfere with the seal. Instead, wipe it dry, run one normal cycle, wait briefly, and observe without disturbing the upper fold. Note whether Wrinkle Care was selected and whether current software is installed. These conditions are specific to the Combo and help GE interpret the report accurately.
For GE UltraFast Combo water in gasket, record when small drip enters the gasket when the door opens occurs, the chosen cycle, and the current indicator state; compare those notes with GE guidance for ge profile ultrafast combo before requesting parts.
Related washer guides
A display fault can be found in GE washer error codes. Water outside the gasket fold should be treated as washer leaking water.