The Maytag Washer LOC Code usually indicates that the Control Lock feature has been activated. When Control Lock is enabled, most washer buttons become disabled to prevent accidental changes during operation.
Many users mistakenly assume the LOC code represents a malfunction, but in most cases it simply means the control panel has been locked. If you’re troubleshooting multiple Maytag washer faults, visit our complete Maytag washer error codes guide for additional information.
Quick Answer: What Does Maytag Washer LOC Code Mean?
The LOC code on a Maytag washer usually means Control Lock is turned on. The washer is preventing button inputs until the lock feature is disabled.
Unlike drainage or water-supply errors, the LOC code is often a normal operating feature rather than a component failure.
Most Common Causes of Maytag Washer LOC Code
- Control Lock was accidentally activated
- A child lock feature was enabled
- A button was held down unintentionally
- Control panel software glitch
- Control panel malfunction
Symptoms That Often Accompany a LOC Code
- Buttons do not respond
- The washer appears frozen
- The cycle cannot be changed
- The display shows LOC continuously
- The machine otherwise appears normal
How to Turn Off Maytag Washer LOC Code
1. Locate the Control Lock Button
Many Maytag washers have a dedicated Control Lock button or a button combination listed on the control panel.
2. Press and Hold the Correct Button
Most models require holding the designated button for approximately 3 seconds.
3. Wait for the Indicator to Clear
Once Control Lock is disabled, the LOC message should disappear and the buttons should respond normally.
4. Restart the Washer
If the display remains locked, try turning the washer off and restarting it.
DIY Repair Cost Guide for Maytag Washer LOC Code
| Repair Step | Estimated Cost |
|---|---|
| Disable Control Lock | $0 |
| Power Reset | $0 |
| Control Panel Inspection | $0 |
| Replace User Interface Panel | $100 – $250 |
| Professional Diagnosis | $75 – $150 |
How to Reset a Maytag Washer Showing LOC
- Turn the washer off.
- Unplug it from power.
- Wait approximately 5 minutes.
- Plug it back in.
- Attempt to disable Control Lock again.
When the LOC Code Will Not Clear
- Control panel malfunction
- Stuck button
- User interface failure
- Control board issue
If the display remains locked after multiple attempts, further diagnosis may be necessary.
FAQ
What does LOC mean on a Maytag washer?
LOC usually means the Control Lock feature is activated.
Is the LOC code an actual error?
In most cases, no. It is usually a user-enabled lock feature rather than a washer failure.
How do I remove the LOC code?
Press and hold the designated Control Lock button for several seconds according to your washer model.
Can unplugging the washer clear the LOC code?
Sometimes a reset helps, but the Control Lock feature typically must be manually disabled.
Final Thoughts
The Maytag Washer LOC Code is usually one of the easiest washer messages to resolve. Most of the time, the code simply indicates that the Control Lock feature has been enabled and needs to be turned off.
If the message remains after disabling Control Lock and performing a reset, the control panel or user interface may require further inspection.